Week 6

This week we are testing Arduino with 9v battery. After an extensive research, we ordered glass cutter and did measurements to cut glass to a size of the mirror.  We are also thinking about the need for a frame which is going to hold mirror and glass, and the materials that we will use to create this. We have nearly finished our 3D model for the console box (housing) in cinema 4D, which we are going to print out on 3D printer.

We are going to take the following steps for making the infinity mirror:

1.       We need a deep frame or at least 1/2 half inch depth.

2.       Prepare the glass by making it perfectly clean.

3.       Spray the glass with a little water and a drop of wash liquid.

4.       Take the roll of window film and cut a piece a couple of inches bigger than the mirror.

5.       Starting from one corner, spray some liquid soap as you slowly lay this over the glass. Smooth out any bubbles and leave to dry.

6.       Assemble the framed glass you tinted, make sure the tinted area is facing the inside of the frame.

7.       Secure the tinted glass with glue.

8.       Add a inner frame to hold the mirror when it is placed on the frame.

9.      
Using a cutter, create a groove for the LED wirings and adapter.

10.   Place LED lights

11.   Glue this frame to the mirrors frame.